For the Public
How to boil tap water
Tap water should be boiled for one minute. Use any clean pot or kettle. Kettles that have automatic shut offs are acceptable.
After boiling, let the water cool by leaving it on the counter or in the refrigerator in covered containers. After water is boiled it can be stored in food grade containers at room temperature or in the refrigerator.
You can bring back flavour by shaking water in a container, pouring the water between two containers, and/or adding a pinch of salt.
Boiled water is required for:
This includes all beverage concentrates such as fruit juice and iced tea where water is added.
This includes washing fruits and vegetables that will not be cooked. Water used as an ingredient does not need to be boiled prior to use, providing it will be brought to a boil during the cooking process.
Coffee machines usually produce water heated to about70 to 80 degrees Celsius, which is sufficient to destroy pathogens. This temperature must be maintained for a sufficient amount of time to ensure that all harmful organisms are destroyed. Therefore, let the coffee stand for at least five minutes before drinking.
This includes daily oral hygiene such as cleaning dentures
Formulas should always be prepared by using boiled tap water or bottled water that is boiled.
It is important to note that freezing does not destroy most pathogens. Bacteria and viruses can survive in frozen products for long periods of time. Discard any ice made from contaminated or potentially contaminated water
Fruit and vegetable washing
Boiled water should be used to wash all produce that is to be eaten raw.
To be safe postpone home canning until the boil water notice has been rescinded.
Beer and wine making
To be safe postpone beer and wine making until the boil water notice has been rescinded.
Water for pets
Veterinarians that were consulted by VIHA recommend that drinking water for pets including dogs, cats, birds and reptiles should also be boiled. Information on water quality for livestock can be accessed at the BC Ministry of Environment water quality objectives website .
People who are immune compromised should always boil their tap water for the purposes above. BC Health files
The following uses do not require boiled water but require additional cleaners or sanitizers :
Cleaning food contact surfaces
Food contact surfaces are all those surfaces that food comes into contact with during the food preparation process. These include counter tops, cutting boards and chopping blocks. Food contact surfaces should be washed with clean water and then sanitized using an acceptable sanitizing agent. Sanitizing agents for food contact surfaces include unscented household bleach, iodophors, and quaternary ammonia compounds.
To prepare stock bleach solutions add 2-4 ml of 5% bleach per liters of water (1 tablespoon per gallon). This will make a 100 to 200 ppm chlorine solution.
Using warm water and soap should be sufficient. Ensure hands are thoroughly dried using paper towel. Use of alcohol sanitizer following hand washing will provide additional safety.
Dishwashing by hand
Dishes washed by hand should be sanitized for two minutes in a separate sink using a bleach solution (2-4 ml of bleach per liter of water or 1 tablespoon per gallon) after the dishes have been washed and rinsed. The dishes should then be left to air dry prior to being used. Attempting to wash and sanitize dishes in the same sink at the same time is not recommended because soap, grease and food particles interfere with the sanitizing process.
Residential home-style dishwashers may not provide a high enough temperature to destroy all pathogens. Dishwashing units that reach 82 degrees Celsius (180 Fahrenheit) for twelve seconds (or an equivalent time-temperature relationship) during the final rinse cycle will destroy pathogens. See the attached PDF file on dishwashing time-temperature relationships.
To optimize dishwasher disinfection you should consider:
- Using the highest temperature setting possible and
- Using the heated dry cycle on the dishwasher.
All other water should be boiled. Simply put, any water that has a chance of being ingested should be boiled.
When will the Boil Water Notice be lifted?
The Boil Water Notice will be lifted once the water is safe to drink.
After a Boil water Notice has been lifted
- Flush all water-using fixtures for 1 minute.
- Run cold-water faucets and drinking fountains for 1 minute before using the water.
- Drain and flush all ice-making machines in your refrigerator.
- Run water softeners through a regeneration cycle.
- Drain and refill hot water tanks set below 45 C (normal setting is 60 C).
- Change any pre-treatment filters (under sink style and refrigerator water filters, carbon block, activated carbon, sediment filters, etc.).
Alternatives to Boiling Water
Although there are alternatives, not all of them will be feasible or practical in all situations. In part, it will depend on how much water you need and what you need it for. Safe alternatives to boiling water include:
- Using commercially prepared bottled water,
- Obtaining water from an approved source that is not on a boil water notice.
- If the water is clear and boiling water is not practical, you can use the following Bleach to Water Chart (PDF) or website as a guide to using bleach.
Important notes: Using bleach (chlorine) to disinfect water is not recommended for Public Notifications that are a result of high turbidity. Turbid water reduces the effects of bleach as a disinfectant. In addition, there may be pathogens present in turbid water that are not affected by bleach.
Bleach does not work well in killing off Cryptosporidium parasites. The amount of bleach needed to kill Cryptosporidium makes the water almost impossible to drink. If Cryptosporidium is in the water, boiling is the best way to make sure water is safe to drink.
Disinfection using unscented household bleach (5% chlorine) works best with warm water. Add bleach to the water, shake or stir for thorough mixing and then let it stand for at least 30 minutes before drinking.
A slight chlorine odor should still be noticeable at the end of the 30-minute waiting period if you have added enough bleach. If not, repeat the dosage and allow the water to stand an additional 15 minutes. If the water has too strong a chlorine taste, allow the water to stand exposed to the air for a few hours or pour it from one clean container to another several times.
Disinfection depends as much on the waiting time after mixing as to the amount of bleach used. The longer the water is left to stand after adding bleach, the more effective the disinfection process will be.